Measurement Guide
Grab a measuring tape, some paper and a pencil, and get started!
How to Measure for Bracelet Size
- Measure around the wrist at the wrist bone. Choose a place where you would normally wear a bracelet. To take the measurement, use a bracelet gauge, a ribbon measuring tape or even a strip of paper and a ruler.
- To use the strip of paper, mark where the end of the bracelet needs to be and then measure the paper with a ruler. No matter the method, the measurement is the wrist size.Increase the wrist measurement in the following increments to determine the bracelet size for how you want the bracelet to fit.
- Add 1/4 to 1/2 inch for a snug fit.
- Add 3/4 to 1 inch for a comfortable fit.
- Add about 1-1/4 inch for a loose fit.
How to Measure for Bangle Size
- Hold your hand as if you were putting on a bangle. Bring all of your fingers together with your thumb and little finger touching.
- Measure around the hand at the widest point with a tape measure or a strip of paper. Be sure to pull the paper or tape measure snug against your skin. Mark the paper with a pen and measure it with a ruler. This measurement is the circumference of your hand.
- Use the following chart to determine the diameter of your hand, based on the circumference. After determining the diameter, choose a bangle that’s at least 1/4 inch larger in diameter than the diameter measurement of your hand,
Convert Hand Circumference to Diameter
-
7-1/2 inches equals approximately 2-3/8 inches in diameter – small
-
8-1/4 inches equals approximately 2-5⁄8 inches in diameter – medium
-
8-5⁄8 inches equals approximately 2-3⁄4 inches in diameter – large
Ring Sizer || How to find your ring size at home
To find your perfect ring size, please click the link below to download your free ring sizing template.